Í The unit cannot communicate with the Bluetooth audio player. … Í The unit cannot communicate with the cell-phone. ö “HF ERROR 68” Í The unit cannot communicate with the cell-phone.
What does HF Error 68 mean on a Kenwood radio?
ö “HF ERROR 68” Í The unit cannot communicate with the cell-phone. ò Cycle the power switch. If this message still appears, press the Reset button on the control unit.
How do I reset my Kenwood radio?
Kenwood Factory Reset
Step 1: Hold Eject CD And Volume button. On the left of the CD slot, you will find the Eject CD button. Step 2: Press The Reset Button. Step 3: Tap the “Initialize All” button. Step 4: Again, press the reset button.
How do I reset my Kenwood dpx502bt?
If the unit fails to operate properly, press the Reset button. The unit returns to factory settings when the Reset button is pressed. Remove the USB device before pressing the Reset button. Pressing the Reset button with the USB device installed can damage the data contained in the USB device.
Why is my Kenwood radio not working?
If the radio will not turn on, first check the fuse located on the back of the radio. If the fuse is burnt, replace with a fuse of the same amperage rating. The guide to replacing the fuse can be found here.
How do I get my Kenwood radio to work?
You can set up the tuner.
Select the Tuner source. Refer to .Press and hold the [AUDIO] button. Enter the Function setting mode.Use the [Control knob] to select “SETTINGS”. Use the [Control knob] to select a Tuner setting item. Use the [Control knob] to select a setting.
How do I get my Kenwood stereo out of Protect Mode?
Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn’t go away on its own, press the reset button. If that doesn’t work, disconnect the power lead from your receiver for 30 seconds and then reconnect it. If it still doesn’t work, it’s time to take it to the dealer.
How do I clear my Kenwood Bluetooth?
You can delete a registered Bluetooth device.
Press [Ú]. “BT MODE” appears and enter the Bluetooth mode.Select “Settings” > “Pairing” > “Device Delete” using [Control] knob. “(name)” appears.Select a Bluetooth device using [Control] knob.Select “YES” using [Control] knob. “Completed” appears.
How do I display the clock on my Kenwood?
13-1. Clock setting
Press and hold the [AUDIO] button. Enter the Function setting mode.Use the [Control knob] to select “SETTINGS” > “CLOCK”. For how to use the [Control knob], refer to
ncG1vNJzZmivp6x7or%2FKZp2oql2esaatjZympmebmru4u86dZKGeXZq%2Fs7vRZm1xZZOdsqS3jKKrZqelqXq4tMCtZJ2nlah6qbKMnqmrp6Jig3l5zJ6Yp2Wfo3qiecqepbCnn5l6s63DoqZo